Key Things You Need To Note When Fitting A Heat Pump.
It is straightforward to provide a heat pump at home. Due to the fact that a heat pump provides heat does not mean that the pump uses a lot of electric power. Geothermal heat pump, air to air system and water source type of air conditioners can be easily installed to homes Heat pumps are used to provide heat and warmth, besides that, it can be used to turn the warm air into the more cooling air during warm temperatures So as to avoid any damage or loss of any component of the heat pump it is essential to follow proper guidelines of the installation. By the use of the right appliance in installing a heat pump it will always be of much importance since the performance of the heat pump will not be compromised.
It is essential to establish the heat pump a small distance away from the wall. By placing the vents of the heat pump some distance from the wall will help increasing sufficient ventilation for the heat pump. it must be put into consideration there must be clearance for ventilation to avoid cases of disastrous fire due to lack of air flow. Always ensure that combustible materials are not used for the pump.Highly flammable materials should be avoided in heat pumps.
Let’s look at placing. The the best place to construct a placing of the heat pump is somewhere within the home compound but outside the house. You should also have a slab on which the heat pump will be placed, and the surrounding should be covered with gravel. Away from the house is the ideal place to place the heat pump because of the vibrations causing disturbance. it is essential for one to put in place two handlers inside the home. The measurement should be 15 feet apart, or the filter wire should be short for the better performance of the heat pump. The Padding is very crucial. Hence the dimension should be one and a half inch.
For the case of those pumps that are placed on roof tops it is vital to have them anchored. So as to have a sufficient anchoring of the pump on the roof it is important to use the isolators as the anchor The curb should be at the same level as the pump and should have the capacity to hold the pump.
It is essential to note that to connect the inside unit to the outside unit you must use copper. Always use copper tuning for the valve cap of the pump and make sure that the valve cap is tight and well-sealed.
